Interactive Board support installation method

Mobile support installation

Step 1: Before installing the mobile support, place the device horizontally on a flat table (screen down). There must be a space between the conference plate and the table with soft objects (such as rubber pads, cotton cloth, foam, etc.) to avoid surface damage.

Step 2: Before installing the support, carefully check the specifications and quantity of fasteners in the support components and accessories to ensure that they are correct.

Step 3: Fasten the hanging arms of the two wall mounting supports using four screws C. To ensure device stability and security, do not hang the device upside down. If the wall mounting bar has been installed on the system, skip this step.

Step 4: Fasten 4 casters E to 1 bottom plate 1 through 16 screws J. Ensure that each castor is connected to the base plate with 4 screws.

Step 5: Fasten the 2PCS support D to 1PCS bottom plate 1 through G-G1-G2.

Step 6: Fasten the 1PCS baffle F and 2PCS support D through 4PCS screws H. Fasten the 1PCS wall mounting plate a and 2PCS bracket D through the sequence of 4PCS screws KK1-K2.

Step 7: Install the device vertically with the long side of the display area horizontal.

The selection of suspension height of the whole machine

1. Choose the maximum touch height A according to the average height of the user. It is recommended that the height should not exceed 1.9M for easy operation.

2. Install the wall hanging plate to the fixed place such as the vertical wall. Measure the height B between the top of the wall hanging plate and the ground for the convenience of installation.

3. By adjusting the distance C between the top of the equipment and the groove of the hanging arm and the height B between the wall hanging plate and the ground, we can meet our touch needs.

4. After the wall hanging plate is fixed, priority should be given to adjusting the height of the hanging arm and selecting the appropriate hole position to meet the needs of our operating equipment.